Speedobmiter + Tac out after installing Sterio??

Feb 2nd, 2003, 10:50 PM

So I was trying to get a new CD player in this Nissan NX 1600 1991.
I poped the Audio fuse and another one.
After replacing all found fuses The sppedobmiter and Tac are'nt working.
Could someone Please help me?
After I repair that I'm also trying to Figure out the wiring chat on the stock sterio.
The new Kenwood I'm trying to install has a red black and yello power wires.
The old system and the wiring in the NX have three red wires with a blue a yello and a black line in them.
The Ground Was connected through the Antanna. (kinda wierd)
Can anyone help me??

SentraStyleEMW · Feb 3rd, 2003, 09:16 AM

Quote:

Originally posted by Bobby2x

So I was trying to get a new CD player in this Nissan NX 1600 1991.
I poped the Audio fuse and another one.
After replacing all found fuses The sppedobmiter and Tac are'nt working.
Could someone Please help me?
After I repair that I'm also trying to Figure out the wiring chat on the stock sterio.
The new Kenwood I'm trying to install has a red black and yello power wires.
The old system and the wiring in the NX have three red wires with a blue a yello and a black line in them.
The Ground Was connected through the Antanna. (kinda wierd)
Can anyone help me??

Is the factory harness plug still attached or did you cut it off? If it is still attached...get yourself a wire harness at any local stereo shop, CC, BB, or walmart for that matter...it makes life a lot easier.

Ninety-Nine SE-L · Feb 5th, 2003, 10:43 AM

also, re-check your fuses. there is a fuse called "meter" that may be the culprit.

kbrassfi · Feb 10th, 2003, 11:48 PM

check the fuses in your engine compartment too, if you haven't figured it out yet, I blew one of these at one point and my tail lights, and dash lights stopped working

Ninety-Nine SE-L · Feb 11th, 2003, 01:29 AM

Quote:

Originally posted by kbrassfi
check the fuses in your engine compartment too, if you haven't figured it out yet, I blew one of these at one point and my tail lights, and dash lights stopped working

Just curious, how did you blow that fuse? have you modifyed your dash lights at all? reason I'm asking is b/c I blew that fuse when I added LEDs to my instrument cluster. When I replaced that fuse, my instrument cluster almost fried.

This has nothing to do with this topic, just so I don't scare anyone.

kbrassfi · Feb 18th, 2003, 10:28 PM

I was installing the stereo and the wire that illuminates the factory stereo touched a ground, I replaced and had no problems. BTW did you replace the fuse with a bigger fuse rating? that can cause problems, because instead of frying the fuse it would get to the dash