Originally Posted by AZ-ZBum

there is a kit for the headunit you can buy at any common stereo shop or best buy, circuit city type place. it will replace the panel and allow a single DIN unit to look normal.

I will look on the way home tonight

I would highly advize against moving the speakers from their stock locations. Far too many hack jobs are out there.

I tend to agree to a point, but, have you seen the stock locations in the dash? Nearly impossible to get to.

I don't know what sizes the speakers are, but since you have two weeks to get it done, just remove the door panels and rear covers and look at them.

The rears appear to be 3.5" - 4" round, just behind the front seats, there are not speakers in the doors, if there were, that is where I would put them.

As for the wiring, I would recommend finding a manual of some sort. Either the factory service manual, Haynes, or Chiltons should have a basic wiring diagram.

Probably good advice, but, really the only unknown that is difficult to figure, is the antennae power wire (to make the antennae go up) thought some one might know.