Hey, i got the pics up. They are located at
www.geocities/aaronford1/nissan1 for right now. I am going to do some rearranging later, but this should work for now. The pics show the input shaft, front and back and the output shaft in which it interfaces. Just showing what is in there. Later I hope to have all my pics up. I did not take the pics to post, but for reassembly purposes, so they don't work as well as I would like.
Oops, almost forgot... Good job on pulling the bearing. It sounds like your handmade puller worked well. My bearing was a little harder to get to. It was the front bearing on the output shaft. The one the Creator had in his hand when he decided to build a truck around it. The bearing did not fail, it was the stamped steel/rivetted retainer that went TU and allowed the bearings to travel around the shaft and made one h**l of a racket.