Quote:
|
Originally Posted by toolapcfan
I'm your man. You're installing it on the B13 I assume?
|
Hey, I've got the alarm part of the remote starter to work but I'm having trouble with the remote start part of the system. Oh yeah, it's on a b13. I followed my chart, only a few things I found different locations to tap into.
Chart:
Remote Starter:
Input/Output I
Function I
Wire I
Location I
Vechicle Wire
----------------------------------------------------------------------------------------------------
30 amp output I
Starter Output I
Yellow I
Ignition Harness** I
Black/White
30 amp output I
Heater/Acc Output I
Green I
Ignition Harness I
White/Blue
30 amp input I
Power Input I
Red I
Ignition Harness I
White
30 amp input I
Power Input I
Red I
Ignition Harness I
White
30 amp output I
Selectable Output I
White I
Ignition Harness I
Black/Yellow
30 amp output I
Ignition Output I
Blue I
Ignition Harness I
Black/Red
Alarm:
(-)250ma output I
Factory Re-arm Output I
Yellow I
NOT USED
(-)250ma output I
Trunk Release Output I
Red/White I
NOT USED
(-)250ma output I
Factory Disarm Output I
Brown I
NOT USED
(-)250ma output I
Starter Kill & Anti-Grind Output I
Orange I
Ignition Harness I
Black/White
Positive output I
(+) Siren Output I
White/Blue I
To siren
Negative input I
Negative Park Brake Input I
Black/White I
Instrument Cluster I
Yellow/Black
Positive input I
Positive Door Pin Input I
Purple I
Positive output I
(+) 10amp Park Light Output I
White I
Headlight Switch/Driver Kick Panel I
Red/Blue (+)
Negative input I
Hood Pin Switch Input I
Green/White I
Negative input I
Negative Door Pin Input I
Green I
Driver Kick Panel I
Red/White(-)
Negative input I
System Ground Input I
Black I
Left Kick Panel I
Ground L
Positive input I
Brake Switch Input I
Pink I
@ Switch on Bracket Above Brake Pedal I
Red/Green (+)
A/C input I
Tach Detection Input I
Blue/White I
@ ECCS or Power Transistor* I
Blue/Black or White
(+ or -) input I
Diesel Glow Plug Input I
Blue I
NOT USED
* ECCS Located Below Center of Dash Behind Center Console. Tach Wire 14 Pin Connector, White @ Pin #1, Blue/Black @ Pin #2. White Only Located @ Power Transistor.
** This Vehicle is equipped with two start wires. Both must be powered in order for vehicle to start when engine is cold.
Tach wire can be tapped on Green/Yellow wire at coil.
The tach wire I tapped at the coil. The e-brake wire I tapped at the e-brake. I plugged my 6 pin power connector to the module. It states "The park light will flash and the horn will chirp 2 times to confirm power up on automatic transmission models. Manual transmission models will flash the park lights and siren 4 times to confirm power up." Well, I what the automatic trans power up. So, I disconnected the 6 pin power wire, the unit is not operated at this time. Any help is appreciated.