Quote:
Originally posted by morepower2
The ride height is set so I am about 3/4 inch off the upper bump stop which is about 3" higher than it was (my stock torsion bars really sagged)
|
Thanks for that elaboration. This is where my suspension seems odd to me. I don't have near that much travel, and I think they're supposed to be the same (Pathfinder vs. Hardbody). I wonder if my lower bump stop is not stock? As you can see from the diagram, I'm less than an inch from the lower wishbone bump stop and just over an inch from the upper wishbone bump stop, so it seems that I have no where near the same travel as yours does. I wonder what the major difference is. If my lower bump stop was a lot smaller, I could easily set the ride height higher to center it between the two stops. But as it is, I'm about an inch from the upper and I only have less than an inch between the lower as well.
I'm going to check out the foam lower stops from AC. I think I'll purchase those first. Got any experience/recommendations regarding the ball joint spacers? That seems like a good economical way to alter the ride height and suspension travel slightly while keeping everything mostly stock.
Thanks again,
