Quote:
Originally posted by javierb14
ya...u can MIG an exhaust system just fine. i would recommend using some argon/co2 and some mild steel wire over the flux if ur fabricating a mild steel exhaust system.
|
Thanks Javier .
I understand you're a very experienced welder so it makes total sense that you would recommend argon/co2 over flux wire.
I still can't help but wonder, is flux wire a good alternative to gas?
I'm a beginner on a tight budget so I would prefer the least expensive MIG setup available.
Also, any idea what type of amperage should I be looking for in a MIG welder?
Thanks
Seth