NissanForums.com :: Nissan Forum - View Single Post - KYB-AGX Strut and RS-R Install

Trippen · Jun 28th, 2006, 04:55 PM

Thanks.....As for the questions.....So far no wheel hop to speak of but then again its an auto and i havent done a full rev and drop into drive. .. When i power brake with my LSD a little hop on or two at the start but not bad I can go into a full tire burn and stays solid no hop. I am going to try to get some vid up soon. of an auto vlsd tire burn.

Even when I jump on it and do spin the rear I havent had any hop. So as for setting in the rear start in the middle 4 or 5 of the 8 and work from there...

Jun 28th, 2006, 04:55 PM	#13 (permalink)
Trippen Nissan Fanatic Join Date: Feb 2006 Location: North of Austin TX Posts: 372	Thanks.....As for the questions.....So far no wheel hop to speak of but then again its an auto and i havent done a full rev and drop into drive. .. When i power brake with my LSD a little hop on or two at the start but not bad I can go into a full tire burn and stays solid no hop. I am going to try to get some vid up soon. of an auto vlsd tire burn. Even when I jump on it and do spin the rear I havent had any hop. So as for setting in the rear start in the middle 4 or 5 of the 8 and work from there... __________________ *Trippen* "I reject your reality and substitute one of my own" Adam-Myth Busters " I dont give Frequent Flyer miles for Guilt Trips" 89 240SX SE FB -KYB AGX w/RS-R race Springs. [ 95 240sx se KA-T Borded .20 over JWT ECU, Z32 MAF, Arias Pistons, Eagle Rods, 50 trim T3/T4 turbo, 50lb MSD, J30 LSD, Custom Drive shaft,D21 flywheel,PLX-R500 and TurboXS Knock lite keeping tabs on everything fastback-hatch-rattle-fix-how-too.html