Quote:
|
Originally Posted by LONDONDERRY
Okay some updates and some questions. I took off the air intake duct work (great idea BTW) and I removed the bolt that secures the ground cable and I assume its also secures the starter as well? I see the intake braket(s) is it required to remove both brackets if not then which one would be recommended to remove.
Thanks
Frank
|
The one i did the bracket is one piece, it splits into 2 at the intake, but it is one piece down by the Drive shaft.
I had to loosen this and disconnect at the bottom to get the starter out. This was the 2.0 SER so yours might be easier.
Watch out for the solenoid wire, slide it off the bracket towards the passenger wheel.
Good luck....