Nissan Forum banner

Valve Cover

1K views 2 replies 2 participants last post by  Sharkster 
#1 ·
Hey everyone! Im new to this forum. Have a question about valve cover replacement.

I have a 2003 Nissan Altima, 2.5L

I am replacing the valve cover, and I was wondering... Should I wait until the motor is cool to change? Or doesnt it matter since it is plastic?

Thanks in advance for all your advice!!:D
 
#2 ·
Probably better to do it when the engine has cooled down; easier on the fingers due to less heat. However, if you want to get technical, the important issue is the rocker cover bolt loosening/tightening sequence and the tightening torque value. If you have a copy of the FSM, it's described there. If you don't have a copy of the FSM, it can be gotten from:

http://www.********.com/archives/use-********-coms-factory-service-manual-database.html

Replace the asterisks with 'nico club' spelled as one word.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top